My Honda HT-R 3009

GXV270 engine engine serial # GJ01-1022473 rear tires - 16x6.50-8 load range b 28psi front tires - 11x4.00 - 5 load range a

tires

$30.27 at amazon prime Ken-Tool 32114 2 Piece Small Tire Iron Set

2 for $62 at amazon Set of 2 16x6.50-8 Turf Tires 4 Ply Tubeless Garden Tractor Lawn mower

Trailer hitch

mowers direct hitch page

mytractorforum.com thread - Anyone used the Great Day Hi-hitch?

Great Day LawnPro Hi-Hitch

Great Day LawnPro Hi-Hitch Model# LNPHH650

Great Day product page

Coleman ATV/UTV Three-Way Hitch

$18.86 at amazon prime Coleman ATV/UTV Three-Way Hitch

Good Vibrations Hitchin Post

Hitchin Post product page Hitchin Post 3-Way Hitchplate

Research

mytractorforum.com lawn-garden-tractors

T J’s small engine Repair llc 1 review · Lawn Mower Repair Service 521 W 7th St · (719) 545-2000 Open until 5:00 PM

Brian’s Small Engines Sales No reviews · Auto Radiator Repair Service 2010 Santa Fe Dr · (719) 545-5304

T & M Power Equipment No reviews · Small Engine Repair Service 613 Santa Fe Dr · (719) 561-2222 Open until 5:30 PM

Briggs & Stratton 1972 8hp

1970 8hp briggs stratton engine

youtube Nascar3244888 - 1974 Briggs 10hp Engine

youtube The Shore Boyz - Episode #3 Briggs and Stratton 8hp Rebuild Part 1

5Tractorguy - Briggs and Stratton 8HP

NomaDairy - 8 HP Briggs & Stratton

youtube OriginalMarkyBoy - 8hp Briggs and Stratton go kart engine Started after 15 years in garage. Just added fuel.

Gilson Snowblower Shop

The Ariens 1960’s and 1970’s Sno-Thro Photo Archive

1972 Canadiana 8HP 26 inch cut snowblower with Briggs and stratton engine part 1

therangerstation.com thread

need help old 1970s briggs engine parts

boosted2.3 08-18-2011, 12:35 AM

I’m retired now but carbs were my extra money for years. It has been my experience that mower carbs don’t wear out. and there are not too many parts to it. The biggest problem with them is dirt. There’s not much to them, just remove it and take it apart and clean it with mineral spirits. there are only 2 small gaskets that you can get just about anywhere that sells mowers, and such. one is on the float bowl, and one where it mounts to the eng. the only place that wears is the throttle shaft and not very often, if it’s good it will be fine. while it’s apart remove the mixer screw,before you remove it just count the turns till is just bearly touches the seat, then take it out and shoot some carb cleaner thru it, you will see it come thru. put it back in and lightly seat it and then back it out however many turns you counted.

youtube kiarra00 - Starting the 1977 8hp Briggs & stratton in my boat